1 - 10 of 143
iec-60061-standard
|
Purpose: To check the minimum outside (major) diameter of the screw thread, dimension "d" of E27 caps on finished lamps shown on sheet 7006-21. ...
2020-09-22 17:15:45
|
|
Go gauges for caps E26, E26/50x39, E26/51x39 & E26d, 7006-27D-3; Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum ...
2020-09-22 17:15:45
|
|
Go gauge for E14 caps on finished lamps, 7006-27F-1 Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E14 caps ...
2020-09-22 17:15:45
|
|
Not go gauges for caps on finished lamps B22, 7006-10-8 According to standard IEC 60061-3 Purpose: To check dimension A in, of caps B22 on finished ...
2020-09-22 17:15:44
|
|
IEC 60061-3 7006-29A-2 E26d Gauge for Caps on Finished Lamps for Testing Protection Against Accidental Contact Dimensions in millimetres The drawing ...
2020-09-22 17:15:44
|
|
Gauge for testing the retention of B15 caps in the holder, 7006-4B-1 According to standard IEC 60061-3 Purpose: To check cap dimensions for retention ...
2020-09-22 17:15:43
|
|
Not go gauges for caps on finished lamps B22, 7006-10-8 According to standard IEC 60061-3 Purpose: To check dimension A in, of caps B22 on finished ...
2020-09-22 17:15:43
|
|
Not go gauges for caps on finished lamps B15, 7006-10-8 According to standard IEC 60061-3 Purpose: To check dimension A in, of caps B15 on finished ...
2020-09-22 17:15:43
|
|
Gauge for testing the retention of B22d caps in the holder, 7006-4B-1 According to standard IEC 60061-3 Purpose: To check cap dimensions for retention ...
2020-09-22 17:15:43
|
|
According to standard IEC 60061-3 Purpose: To check dimensions A max., N min. D1 min., D1 max., and the diametrical position of the pins of caps B15 ...
2020-09-22 17:15:43
|