71 - 80 of 196
other standard
|
Dual-channel UV Radiation Dosimeter with 365 nm Probe & 420 nm Probe for UV-A Irradiance Measurement This instrument is light chemistry, polymer ...
|
|
BS EN 60061-3,NF EN 60061-3,DIN EN 60061-3,IEC EN 60061-3,CEI 60061-3 7006-27F-1 Go Gauge for E14 Caps on Finished Lamps Go gauge for E14 caps on ...
|
|
CEI60061-3, EN60061-3, DIN60061-3, IEC60061-3, BS60061-3 7006-27B-1 Go Gauge for E27 Caps on Finished Lamps PURPOSE: To check the maximum dimensions ...
|
|
IEC EN 60061-3 7006-55-1 Gauge for Finished Lamps Fitted with E14 Caps for Testing Protection Against Accidental Contact The gauge is shown in the ...
|
|
EN60968 / IEC60968 Figure 2 - Holder for Torsion Test on Lamps with Screw Caps of E14 Lamp Holder Torque Gauge Objective: To detect the lamp holder of ...
|
|
CEI 60061-3, NF EN 60061-3, DIN EN 60061-3, IEC EN 60061-3, BS EN 60061-3 7006-54-1 E14 Gauge for Finished Lamps Fitted with E14 Caps for Testing ...
|
|
CEI60061-3, EN60061-3, DIN60061-3, IEC60061-3, BS60061-3 7006-28A-1 Not Go Gauge for E27 Caps on Finished Lamps Purpose: To check the minimum outside ...
|
|
IEC60061 7006-27C-1 "Go" Gauge for dimension "S1" of E27 Caps on Finished Lamps Shown on Sheet 7004-21 Purpose: To check the dimension S1 minimum and ...
|
|
IEC60061 7006-50-1 Gauge for Finished Lamps Fitted with E27 Caps for Testing Contact Making in I.E.C. Holders Purpose: To check lamp dimensions for ...
|
|
Objective: To detect the lamp holder of mechanical strength. Torsion resistance The cap shall remain firmly attached to the bulb or that part of the ...
|