41 - 50 of 196
other standard
|
Acceptance gauge for B22d caps intended for automatic wire threading, 7006-3-1 According to standard IEC 60061-3 Purpose: To check the suitability of ...
|
|
Go gauge for caps on finished lamps E17, 7006-27K-1 Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E17 caps ...
|
|
Go gauges for caps E26, E26/50x39, E26/51x39 & E26d, 7006-27D-3; Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum ...
|
|
Purpose: To check the minimum outside (major) diameter of the screw thread, dimension "d" of E27 caps on finished lamps shown on sheet 7006-21. ...
|
|
Go and not go gauge for unmounted bi-pin cap(not for use on finished lamps) G13, 7006-44-4 Purpose: To check dimensions E min., E max., F min., G max....
|
|
Go gauge for caps on finished lamps E40, 7006-27-7 Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E40 caps ...
|
|
Gauge for finished lamps fitted with E40 caps for testing protection against accidental contact E40, 7006-53-1 Purpose: To check protection against ...
|
|
Gauge for testing contact-making of lamps fitted with caps E26/24 7006-29-3 Purpose: To check lamp dimensions for contact-making in E26/24 lampholders...
|
|
For details of base GU5.3/MR16, see sheet 7004-109. PURPOSE: To check the base GU5.3 in the following respects: -the diameter of the individual pins ...
|
|
The drawing is intended only to illustrate the essential dimensions of the gauge. For details of cap E39, see sheet 7004-24A. PURPOSE: To check the ...
|