31 - 40 of 196
other standard
|
EN61032 Figure 12 - Jointed Child Finger Test Probe 18 of Small Finger Probe 8,6 mm (36 months~14 years old) IEC61032 Test Probe 18, Children Test ...
|
|
Spring Hammer Impact Calibration Device Principle of calibration: The principle of this calibration procedure is to compare the energy provided by a ...
|
|
Go gauge for E14 caps on finished lamps, 7006-27F-1 Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E14 caps ...
|
|
Purpose: To check dimensions A max., N min. D1 min., D1 max., and the diametrical position of the pins of caps B15 on finished lamps. Testing: The cap ...
|
|
For details of cap R17d, see sheet 7004-56. PURPOSE: To check dimensions J min., K min., K max. and N min. of R17d caps on finished lamps. TESTING: ...
|
|
IEC60061-3 G5 Lamp Cap Go Gauge (7006-46A-3) Purpose: To check dimensions E max., F min., F max., and the combined pin diameter and displacement of ...
|
|
IEC 60061-3 7006-29A-2 E26d Gauge for Caps on Finished Lamps for Testing Protection Against Accidental Contact Dimensions in millimetres The drawing ...
|
|
Go and not go gauge for bases GU10, 7006-121-1 Purpose: To check the base GU10 in the following respects: -The diameter of the individual pins ...
|
|
The plunger of the gauge is shown in the test position. When the plunger is at rest, surface W shall be retracted deeper than surface V. PURPOSE: To ...
|
|
Go gauge for caps on finished lamps E40, 7006-27-7 Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E40 caps ...
|