91 - 100 of 196
other standard
|
Go gauges for caps E26, E26/50x39, E26/51x39 & E26d, 7006-27D-3; Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum ...
|
|
Not go gauge for caps E26, E26/50x39, E26/51x39 & E26d, 7006-29L-4 Purpose: To check the minimum outside (major) diameter of the screw thread, ...
|
|
Objective: To detect the lamp holder of mechanical strength. Torsion resistance The cap shall remain firmly attached to the bulb or that part of the ...
|
|
The drawing is intended only to illustrate the essential dimensions of the gauge. For details of cap E39, see sheet 7004-24A. PURPOSE: To check the ...
|
|
Additional go gauge for caps on finished lamps E12, 7006-27J-1 Purpose: To check the maximum outside (major) diameter, dimension d, of E12 caps on ...
|
|
IEC60065 Dielectric Strength Test Instrument for Electrical safety testing Application: It's mainly used for testing thin-layer insulation material ...
|
|
Not go gauge for caps on finished lamps E12, 7006-28C-1 Purpose: To check the minimum outside (major) diameter of the screw thread, dimension d, of ...
|
|
Objective: To detect the lamp holder of mechanical strength. Torsion resistance The cap shall remain firmly attached to the bulb or that part of the ...
|
|
Not go gauge for caps on finished lamps E17, 7006-28F-1 Purpose: To check the minimum outside (major) diameter of the screw thread, dimension d, of ...
|
|
According to standard IEC 60061-3 Purpose: To check dimension G min. of bases G9. Testing: Without use undue force it shall not be possible for the ...
|