51 - 60 of 196
other standard
|
Not go gauge for caps on finished lamps E12, 7006-28C-1 Purpose: To check the minimum outside (major) diameter of the screw thread, dimension d, of ...
|
|
The sharp part of the edge of the thread shall be broken with a radius of 0.2 mm to 0.3 mm. PURPOSE: To check the maximun dimensions of the crew ...
|
|
IEC60061-3 G5 Go Not Go Gauge for Lamp (7006-46-3) Purpose: To check dimensions E min., E max., F min., G max., Hmax., and the combined pin diameter ...
|
|
Not go gauges for caps on finished lamps B22, 7006-10-8 According to standard IEC 60061-3 Purpose: To check dimension A in, of caps B22 on finished ...
|
|
Go gauge for caps on finished lamps E12, 7006-27H-1 Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E12 caps ...
|
|
Not go gauge for caps on finished lamps E17, 7006-28F-1 Purpose: To check the minimum outside (major) diameter of the screw thread, dimension d, of ...
|
|
PURPOSE: To check the base GU4 in the following respects: -the diameter of the individual pins (dimension E); -the combined displacement and diameter ...
|
|
UV Radiation Dosimeter with 365 nm Probe Probe for UV-A Irradiance Measurement This instrument is light chemistry, polymer material aging, testing, ...
|
|
UV Radiation Dosimeter with 420 nm Probe Probe for UV-A Irradiance Measurement This instrument is light chemistry, polymer material aging, testing, ...
|
|
Model RK5001 capacity 1kVA Debugging SPWM INPUT Phase 1φ2W Voltage 220V±10% Frequency 47Hz-63Hz OUTPUT Phase 1φ2W Voltage Low=0-144VAC High=0-288VAC ...
|