121 - 130 of 143
iec-60061-standard
|
The gauge is shown in the test position. In the rest position the plunger shall be above plane V. PURPOSE: To check protection against accidental ...
2016-08-13 11:19:01
|
|
Not go gauge for E14 caps on finished lamps, 7006-28B-1 Purpose: To check the minimum outside (major) diameter of the screw thread, dimension d, of ...
2016-08-13 11:21:30
|
|
Go gauge for E14 caps on finished lamps, 7006-27F-1 Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E14 caps ...
2016-08-13 11:23:01
|
|
Go gauge for caps on finished lamps E12, 7006-27H-1 Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E12 caps ...
2016-08-13 11:24:05
|
|
Not go gauge for caps on finished lamps E12, 7006-28C-1 Purpose: To check the minimum outside (major) diameter of the screw thread, dimension d, of ...
2016-08-13 11:26:06
|
|
Additional go gauge for caps on finished lamps E12, 7006-27J-1 Purpose: To check the maximum outside (major) diameter, dimension d, of E12 caps on ...
2016-08-13 11:27:23
|
|
E10 Go Gauge for caps on finished lamps according to IEC60061 7006-27A-2 The drawing is intended only to illustrate the essential dimensions of the ...
2016-08-13 11:28:49
|
|
Not go gauge for caps on finished lamps E17, 7006-28F-1 Purpose: To check the minimum outside (major) diameter of the screw thread, dimension d, of ...
2016-10-13 15:22:02
|
|
Go gauge for caps on finished lamps E17, 7006-27K-1 Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E17 caps ...
2016-08-16 10:18:32
|
|
Not go gauge for caps E26, E26/50x39, E26/51x39 & E26d, 7006-29L-4 Purpose: To check the minimum outside (major) diameter of the screw thread, ...
2016-08-16 10:20:03
|