111 - 120 of 143
iec-60061-standard
|
IEC60061-3: 7006-24C-1 E39 No Go Gauge for Caps on Finished Lamps The drawing is intended only to illustrate the essential dimensions of the gauge. ...
2016-08-12 17:02:28
|
|
IEC60061-3: 7006-24B-1 E39 Go Gauge for Caps on Finished Lamps The sharp part of the edge of the thread shall be broken with a radius of 0.2 mm to 0.3 ...
2016-08-12 17:04:03
|
|
IEC60061-3 7006-24A-1 Gauge for Finished Lamps Fitted with E39 Caps for Testing Contact-Making The plunger of the gauge is shown in the test position. ...
2016-08-12 17:05:14
|
|
IEC60061-3: 7006-46A-3 Go Gauge for Bi-pin Cap on Finished Lamps G5 IEC60061-3 G5 Lamp Cap Go Gauge (7006-46A-3) Purpose: To check dimensions E max., ...
2016-08-13 10:56:20
|
|
IEC60061-3: 7006-46-3 Go and Not Go Gauge for Unmounted Bi-pin Cap G5 (Not for Use on Finished Lamps) IEC60061-3 G5 Go Not Go Gauge for Lamp (7006-46...
2016-08-13 10:57:37
|
|
Go and not go gauge for unmounted bi-pin cap(not for use on finished lamps) G13, 7006-44-4 Purpose: To check dimensions E min., E max., F min., G max....
2016-08-13 10:59:42
|
|
Go gauge for bi-pin cap on finished lamp G13, 7006-45-4 Purpose: To check dimensions E max., F min., F max. and the combined pin diameter and ...
2016-08-13 11:03:46
|
|
Go and not go gauge for bases GU10, 7006-121-1 Purpose: To check the base GU10 in the following respects: - the diameter of the individual pins ...
2016-08-13 11:07:00
|
|
The drawing is intended only to illustrate the essential dimensions of the gauge. For details of base GU4, see sheet 7004-108. PURPOSE: To check the ...
2016-08-13 11:11:03
|
|
Go gauge for dimension "S1" of E14 caps on finished lamps, 7006-27G-1 Purpose: To check the dimensions S1 minimum and S1 maximum of E14 caps on ...
2016-08-13 11:17:36
|