291 - 300 of 535
other-standard
|
IEC 60061-3 7006-29A-2 E26d Gauge for Caps on Finished Lamps for Testing Protection Against Accidental Contact Dimensions in millimetres The drawing ...
2020-09-22 17:15:44
|
|
IEC60061-3 G5 Lamp Cap Go Gauge (7006-46A-3) Purpose: To check dimensions E max., F min., F max., and the combined pin diameter and displacement of ...
2020-09-22 17:15:44
|
|
Purpose: To check dimensions A max., N min. D1 min., D1 max., and the diametrical position of the pins of caps B15 on finished lamps. Testing: The cap ...
2020-09-22 17:15:44
|
|
Go gauge for E14 caps on finished lamps, 7006-27F-1 Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E14 caps ...
2020-09-22 17:15:44
|
|
Spring Hammer Impact Calibration Device Principle of calibration: The principle of this calibration procedure is to compare the energy provided by a ...
2020-09-22 17:15:44
|
|
Go gauges for caps E26, 7006-27D-3 Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E26 caps on finished lamps...
2020-09-22 17:15:44
|
|
Not go gauge for caps on finished lamps E17, 7006-28F-1 Purpose: To check the minimum outside (major) diameter of the screw thread, dimension d, of ...
2020-09-22 17:15:44
|
|
Go and not go gauge for bases GU10, 7006-121-1 Purpose: To check the base GU10 in the following respects: - the diameter of the individual pins ...
2020-09-22 17:15:44
|
|
The drawing is intended only to illustrate the essential dimensions of the gauge. For details of cap E39, see sheet 7004-24A. PURPOSE: To check the ...
2020-09-22 17:15:45
|
|
Additional go gauge for caps on finished lamps E12, 7006-27J-1 Purpose: To check the maximum outside (major) diameter, dimension d, of E12 caps on ...
2020-09-22 17:15:45
|