261 - 270 of 535
other-standard
|
Not go gauge for caps on finished lamps E40, 7006-28D-1 Purpose: To check the minimum outside (major) diameter of the screw thread, dimension d, of ...
2020-09-22 17:15:43
|
|
Not go gauge for caps on finished lamps E17, 7006-28F-1 Purpose: To check the minimum outside (major) diameter of the screw thread, dimension d, of ...
2020-09-22 17:15:43
|
|
Objective: To detect the lamp holder of mechanical strength. Torsion resistance The cap shall remain firmly attached to the bulb or that part of the ...
2020-09-22 17:15:43
|
|
Not go gauge for caps on finished lamps E12, 7006-28C-1 Purpose: To check the minimum outside (major) diameter of the screw thread, dimension d, of ...
2020-09-22 17:15:43
|
|
IEC60065 Dielectric Strength Test Instrument for Electrical safety testing Application: It's mainly used for testing thin-layer insulation material ...
2020-09-22 17:15:43
|
|
IEC60061 7006-50-1 Gauge for Finished Lamps Fitted with E27 Caps for Testing Contact Making in I.E.C. Holders Purpose: To check lamp dimensions for ...
2020-09-22 17:15:43
|
|
IEC60061 7006-27C-1 "Go" Gauge for dimension "S1" of E27 Caps on Finished Lamps Shown on Sheet 7004-21 Purpose: To check the dimension S1 minimum and ...
2020-09-22 17:15:43
|
|
CEI60061-3, EN60061-3, DIN60061-3, IEC60061-3, BS60061-3 7006-28A-1 Not Go Gauge for E27 Caps on Finished Lamps Purpose: To check the minimum outside ...
2020-09-22 17:15:43
|
|
CEI 60061-3, NF EN 60061-3, DIN EN 60061-3, IEC EN 60061-3, BS EN 60061-3 7006-54-1 E14 Gauge for Finished Lamps Fitted with E14 Caps for Testing ...
2020-09-22 17:15:43
|
|
EN60968 / IEC60968 Figure 2 - Holder for Torsion Test on Lamps with Screw Caps of E14 Lamp Holder Torque Gauge Objective: To detect the lamp holder of ...
2020-09-22 17:15:43
|