331 - 340 of 535
other-standard
Additional go gauge for caps on finished lamps E12, 7006-27J-1 Purpose: To check the maximum outside (major) diameter, dimension d, of E12 caps on ...
2020-09-22 17:15:43
|
The drawing is intended only to illustrate the essential dimensions of the gauge. For details of cap E39, see sheet 7004-24A. PURPOSE: To check the ...
2020-09-22 17:15:43
|
Objective: To detect the lamp holder of mechanical strength. Torsion resistance The cap shall remain firmly attached to the bulb or that part of the ...
2020-09-22 17:15:43
|
Not go gauge for caps E26, E26/50x39, E26/51x39 & E26d, 7006-29L-4 Purpose: To check the minimum outside (major) diameter of the screw thread, ...
2020-09-22 17:15:43
|
Go gauges for caps E26, E26/50x39, E26/51x39 & E26d, 7006-27D-3; Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum ...
2020-09-22 17:15:43
|
Gauge for E27/51x39 caps on finished lamps for testing protect against accidental contact, code 7006-51-2; Purpose: To check protection against ...
2020-09-22 17:15:43
|
Objective: To detect the lamp holder of mechanical strength. Torsion resistance The cap shall remain firmly attached to the bulb or that part of the ...
2020-09-22 17:15:43
|
Objective: To detect the lamp holder of mechanical strength. Torsion resistance The cap shall remain firmly attached to the bulb or that part of the ...
2020-09-22 17:15:43
|
CEI60061-3, EN60061-3, DIN60061-3, IEC60061-3, BS60061-3 7006-27B-1 Go Gauge for E27 Caps on Finished Lamps PURPOSE: To check the maximum dimensions ...
2020-09-22 17:15:44
|
Go gauge for caps on finished lamps E12, 7006-27H-1 Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E12 caps ...
2020-09-22 17:15:44
|