341 - 350 of 535
other-standard
IEC60061-3 G5 Go Not Go Gauge for Lamp (7006-46-3) Purpose: To check dimensions E min., E max., F min., G max., Hmax., and the combined pin diameter ...
2020-09-22 17:15:44
|
The sharp part of the edge of the thread shall be broken with a radius of 0.2 mm to 0.3 mm. PURPOSE: To check the maximun dimensions of the crew ...
2020-09-22 17:15:44
|
Gauge for finished lamps fitted with E40 caps for testing protection against accidental contact E40, 7006-53-1 Purpose: To check protection against ...
2020-09-22 17:15:44
|
Go gauge for caps on finished lamps E17, 7006-27K-1 Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E17 caps ...
2020-09-22 17:15:44
|
For details of cap R17d, see sheet 7004-56. PURPOSE: To check dimensions J min., K min., K max. and N min. of R17d caps on finished lamps. TESTING: ...
2020-09-22 17:15:44
|
Conform to the IEC60335-2-14 clause 20.2. Means of a test probe that is similar to test probe B of IEC 61032 but having a circular stop face with a ...
2020-09-22 17:15:46
|
IEC 60884 Figure 10 and IEC 60884 Figure 9 Through Shutters Gauge for Checking Non-Accessibility of Live Parts Basic Introduction: 1. According to : ...
2020-09-22 17:15:46
|
IEC61032:1997 / IEC61032:2008 / BS EN61032 / CEI 61032 IP1X Test Probe A with 50N Force Specification: IP1X Probe A /Test Probe A 1, According to : GB...
2020-09-22 17:15:46
|
Meets IEC 61010. Accessibility probes are used to test the size of openings to ensure that fingers and objects do not have access to hazardous parts ...
2020-09-22 17:15:46
|
Meets IEC 60529. Accessibility probes are used to test the size of openings to ensure that fingers and objects do not have access to hazardous parts ...
2020-09-22 17:15:46
|