51 - 60 of 118
iec 60061 standard
|
NEN / BS / DIN / EN 60061-3 7006-129A-1 G9 Not Go Gauge for Base According to standard IEC 60061-3 Purpose: To check dimension G min. of bases G9. ...
|
|
Go gauge for bi-pin cap on finished lamp G13, 7006-45-4 Purpose: To check dimensions E max., F min., F max. and the combined pin diameter and ...
|
|
Go and not go gauge for unmounted bi-pin cap(not for use on finished lamps) G13, 7006-44-4 Purpose: To check dimensions E min., E max., F min., G max....
|
|
IEC60061-3: 7006-46-3 Go and Not Go Gauge for Unmounted Bi-pin Cap G5 (Not for Use on Finished Lamps) IEC60061-3 G5 Go Not Go Gauge for Lamp (7006-46...
|
|
IEC60061-3: 7006-46A-3 Go Gauge for Bi-pin Cap on Finished Lamps G5 IEC60061-3 G5 Lamp Cap Go Gauge (7006-46A-3) Purpose: To check dimensions E max., ...
|
|
IEC60061-3 7006-24A-1 Gauge for Finished Lamps Fitted with E39 Caps for Testing Contact-Making The plunger of the gauge is shown in the test position. ...
|
|
IEC60061-3: 7006-24B-1 E39 Go Gauge for Caps on Finished Lamps The sharp part of the edge of the thread shall be broken with a radius of 0.2 mm to 0.3 ...
|
|
IEC60061-3: 7006-24C-1 E39 No Go Gauge for Caps on Finished Lamps The drawing is intended only to illustrate the essential dimensions of the gauge. ...
|
|
IEC60061-3: 7006-27-7 E40 Go Gauge for Caps on Finished Lamps Go gauge for caps on finished lamps E40, 7006-27-7 Purpose: To check the maximum ...
|
|
IEC60061-3: 7006-28D-1 E40 No Go Gauge for Caps on Finished Lamps Purpose: To check the minimum outside (major) diameter of the screw thread, ...
|