31 - 40 of 118
iec 60061 standard
|
Not go gauges for caps on finished lamps B15, 7006-10-8 According to standard IEC 60061-3 Purpose: To check dimension A in, of caps B15 on finished ...
|
|
According to standard IEC 60061-3 Purpose: To check dimensions A max., N min. D1 min., D1 max., and the diametrical position of the pins of caps B15 ...
|
|
Gauges for testing the insertion of caps in lampholders B15d, 7006-4A-2 According to standard IEC 60061-3 Purpose: To check B15d cap dimensions for ...
|
|
Gauges for testing the insertion of caps in lampholders B22d, 7006-4A-2 According to standard IEC 60061-3 Purpose: To check B22d cap dimensions for ...
|
|
Acceptance gauge for B22d caps intended for automatic wire threading, 7006-3-1 According to standard IEC 60061-3 Purpose: To check the suitability of ...
|
|
According to standard IEC 60061-3 Purpose: To check dimensions A max., N min. D1 min., D1 max., and the diametrical position of the pins of caps B22 ...
|
|
Not go gauges for caps on finished lamps B22, 7006-10-8 According to standard IEC 60061-3 Purpose: To check dimension A in, of caps B22 on finished ...
|
|
Gauge for testing the retention of B22d caps in the holder, 7006-4B-1 According to standard IEC 60061-3 Purpose: To check cap dimensions for retention ...
|
|
E10 Go Gauge for caps on finished lamps according to IEC60061 7006-27A-2 The drawing is intended only to illustrate the essential dimensions of the ...
|
|
Additional go gauge for caps on finished lamps E12, 7006-27J-1 Purpose: To check the maximum outside (major) diameter, dimension d, of E12 caps on ...
|