41 - 50 of 118
iec 60061 standard
|
Not go gauge for caps on finished lamps E12, 7006-28C-1 Purpose: To check the minimum outside (major) diameter of the screw thread, dimension d, of ...
|
|
Go gauge for caps on finished lamps E12, 7006-27H-1 Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E12 caps ...
|
|
Go gauge for E14 caps on finished lamps, 7006-27F-1 Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E14 caps ...
|
|
Not go gauge for E14 caps on finished lamps, 7006-28B-1 Purpose: To check the minimum outside (major) diameter of the screw thread, dimension d, of ...
|
|
The gauge is shown in the test position. In the rest position, the plunger shall be above plane V. PURPOSE: To check lamp dimensions for contact ...
|
|
The gauge is shown in the test position. In the rest position the plunger shall be above plane V. PURPOSE: To check protection against accidental ...
|
|
Go gauge for dimension "S1" of E14 caps on finished lamps, 7006-27G-1 Purpose: To check the dimensions S1 minimum and S1 maximum of E14 caps on ...
|
|
IEC 60061-3 7006-57-3 Go and Not Go Gauge for Recessed Double Contact Cap R17d on Finished Lamps For details of cap R17d, see sheet 7004-56. PURPOSE: ...
|
|
The drawing is intended only to illustrate the essential dimensions of the gauge. For details of base GU4, see sheet 7004-108. PURPOSE: To check the ...
|
|
Go and not go gauge for bases GU10, 7006-121-1 Purpose: To check the base GU10 in the following respects: - the diameter of the individual pins ...
|