471 - 480 of 535
other-standard
|
IEC60061-3: 7006-46-3 Go and Not Go Gauge for Unmounted Bi-pin Cap G5 (Not for Use on Finished Lamps) IEC60061-3 G5 Go Not Go Gauge for Lamp (7006-46...
2016-08-13 10:57:37
|
|
Go and not go gauge for unmounted bi-pin cap(not for use on finished lamps) G13, 7006-44-4 Purpose: To check dimensions E min., E max., F min., G max....
2016-08-13 10:59:42
|
|
Go gauge for bi-pin cap on finished lamp G13, 7006-45-4 Purpose: To check dimensions E max., F min., F max. and the combined pin diameter and ...
2016-08-13 11:03:46
|
|
Go and not go gauge for bases GU10, 7006-121-1 Purpose: To check the base GU10 in the following respects: - the diameter of the individual pins ...
2016-08-13 11:07:00
|
|
The drawing is intended only to illustrate the essential dimensions of the gauge. For details of base GU4, see sheet 7004-108. PURPOSE: To check the ...
2016-08-13 11:11:03
|
|
IEC 60061-3 7006-57-3 Go and Not Go Gauge for Recessed Double Contact Cap R17d on Finished Lamps For details of cap R17d, see sheet 7004-56. PURPOSE: ...
2016-08-13 11:14:38
|
|
Go gauge for dimension "S1" of E14 caps on finished lamps, 7006-27G-1 Purpose: To check the dimensions S1 minimum and S1 maximum of E14 caps on ...
2016-08-13 11:17:36
|
|
The gauge is shown in the test position. In the rest position the plunger shall be above plane V. PURPOSE: To check protection against accidental ...
2016-08-13 11:19:01
|
|
The gauge is shown in the test position. In the rest position, the plunger shall be above plane V. PURPOSE: To check lamp dimensions for contact ...
2016-08-13 11:20:25
|
|
Not go gauge for E14 caps on finished lamps, 7006-28B-1 Purpose: To check the minimum outside (major) diameter of the screw thread, dimension d, of ...
2016-08-13 11:21:30
|