431 - 440 of 535
other-standard
|
IEC 61032:1997 Figure 14 Milling Test Probe 31 of Access Probes to Hazardous Mechanical Parts This probe is intended to verify the protection against ...
2016-08-11 14:40:21
|
|
IEC 61032:1997 Figure 14 Milling Test Probe 31 of Access Probes to Hazardous Mechanical Parts This probe is intended to verify the protection against ...
2016-08-11 14:41:31
|
|
2,5mm Test Rod - Test Probe C of IEC61032 Basic Introduction: 1. According to: IEC 61032:1997 / IEC 60529:2001 / IEC 60065 / IEC 60598 and UL 2. IP3X ...
2016-08-11 16:15:18
|
|
50mm Sphere Test Probe A with Baffle and Handle Specification: IP1X Probe A /Test Probe A 1, According to: IEC 61032:1997 / IEC 60529:2001 and UL; 2, ...
2016-08-11 15:11:05
|
|
Small Finger Probe 5,6 Test Probe 19 of IEC 61032 IEC 61032 Figure 13 – Test probe 19 (small finger probe ∅ 5,6) – Finger: metal material – Handle: ...
2016-08-11 15:15:24
|
|
IEC 61032:1997 Test Probe D IP4X Test Wire 1.0 mm Basic Introduction: 1. According to: GB/T4208-2008 / IEC 61032:1997 / IEC 60529:2001 / IEC 60065 / ...
2016-08-11 16:15:08
|
|
Fa8 Not Go Gauge for Single-pin Cap, 7006-40A-1. Purpose: For the control of dimension E min. of sheet 7004-57. Testing: When the gauge is applied to ...
2016-08-12 15:15:40
|
|
Fa8 Go Gauge for Single-pin Cap, 7006-40-1. Purpose: For the control of dimensions E max., F max., F min., G max., and H max. of sheet 7004-57. ...
2016-08-12 15:16:40
|
|
IEC60061-3: 7006-11C-1 BAZ15d Go Gauge for Cap on Finished Lamps PURPOSE: To check dimensions A max., D1 min., D1 max., L max. and the angular ...
2016-08-12 15:18:03
|
|
IEC60061-3: 7006-19A-1 BAU15s Go Gauge for Cap on Finished Lamp PURPOSE: To check dimensions A max., D1 min., D1 max., N min. and the angular ...
2016-08-12 15:19:35
|