381 - 390 of 540
Products
IEC 60061-3 7006-29A-2 E26d Gauge for Caps on Finished Lamps for Testing Protection Against Accidental Contact Dimensions in millimetres The drawing ...
|
Go and not go gauge for bases GU10, 7006-121-1 Purpose: To check the base GU10 in the following respects: -The diameter of the individual pins ...
|
The plunger of the gauge is shown in the test position. When the plunger is at rest, surface W shall be retracted deeper than surface V. PURPOSE: To ...
|
Go gauge for caps on finished lamps E40, 7006-27-7 Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E40 caps ...
|
Acceptance gauge for B22d caps intended for automatic wire threading, 7006-3-1 According to standard IEC 60061-3 Purpose: To check the suitability of ...
|
Go gauge for caps on finished lamps E17, 7006-27K-1 Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E17 caps ...
|
Go gauges for caps E26, E26/50x39, E26/51x39 & E26d, 7006-27D-3; Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum ...
|
Purpose: To check the minimum outside (major) diameter of the screw thread, dimension "d" of E27 caps on finished lamps shown on sheet 7006-21. ...
|
Go and not go gauge for unmounted bi-pin cap(not for use on finished lamps) G13, 7006-44-4 Purpose: To check dimensions E min., E max., F min., G max....
|
Go gauge for caps on finished lamps E40, 7006-27-7 Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E40 caps ...
|